导读：车间预涂底漆使对于海洋设备等恶劣环境下钢材的一种保养保护，对除锈达到要求经过严格表面处理的钢板涂刷水性车间预涂底漆，能够有效的保证钢板在更长时间内部生锈、腐蚀。也就是说，它作为底漆来说，起到了十分关键性的作用，那么，它的施工应该如何进行? Takeaway: shop shop primer make steel for Marine equipment under the bad environment of a maintenance of protection, the rust removal is achieved through strict surface treatment of steel besmear brushs water workshop shop primer, can effectively guarantee the steel plate in the inner rusting, corrosion for a longer time. In other words, it plays a crucial role as a primer, so how should it be built 1、 水性车间预涂底漆的处理要求 一般在钢板上进行涂刷水性车间预涂底漆，要将钢板进行除锈处理。此步骤要求十分严格。 It is commonly used on the steel plate to apply the primer to the water-based workshop and to remove the steel plate for the rust treatment. This step is very strict. 首先要将钢板上的水分、污泥及疏松的氧化皮通过加热、吹皮，钢铁丝刷涂等方式去除浮锈。这是为了得到一个干燥、清洁的表面。 The first step is to remove the rust from the water, the sludge and the loose oxidation skin of the steel plate by heating, blowing and brushing. This is to get a dry, clean surface. 然后用钢丸或者钢铁抛与钢板表面上，将钢铁绣和氧化皮完全除尽，呈现出金属本色。一般除锈要达到Sa2.5级，表面粗糙度达到30-60微米，表面清洁度也需要达到ClassI级。才能够保证漆膜在钢板上有完美的附着效果。 Then, with the steel pellets or steel sheets and steel plates, the steel embroidery and the skin of the iron oxide are completely removed, rendering the metal as a metal. General cleaning to Sa2.5 level, the surface roughness of up to 30 to 60 micrometers, surface cleanliness level also need to achieve ClassI. It is possible to ensure that the coating has a perfect adhesion effect on the steel plate. 2、 水性车间预涂底漆的正确涂刷 进行完水性车间预涂底漆表面预处理之后，开始准备涂刷。整个涂刷需要在无尘环境中进行，除去表面灰尘之后立刻用高压喷枪喷已经配置好的水性车间预涂底漆，需要经过一段时间的干燥使钢板达到干燥程度。 After finishing the pre-coated surface of the water-based workshop, prepare the brush. The coating shall be carried out in a clean environment, immediately after to remove surface dust with high pressure spray gun configured water-based workshop shop primer, drying needs to be over a period of time to make the steel plate to dry. 整体涂装可按照水性底漆通用涂刷方法，值得注意的是要控制涂料的黏度，喷枪压力合理控制，以及控制涂装间隔及重涂时间。 Coating can be in accordance with the overall waterborne primer coating method, it is worth noting that trying to control the viscosity of coating, spray gun pressure control, as well as the control of coating and painting between time. |
